Powertrax 3710 Bedienungsanleitung PDF herunterladen (Seite 4)

LOCK-RIGHT Installaons Covered

in This Manual

Integral carrier axles. Typical of these is Spicer®, Jeep®

AMC-20, G.M.® 10-, 12-, and 14-bolt, Ford® 7.5-inch and 8.8-inch,

Toyota® Land Cruiser; similar axles, with and without C-Clips.

Preliminary Steps

The following steps are only a general guide to prelimi-

nary operaons used for preparing your vehicle for LOCK-RIGHT

installaon. For detailed informaon, refer to your shop manual.

In general, the preliminary steps include:

a) Blocking the vehicle, pung transmission in neutral;

b) Loosening the wheel lug nuts (oponal with C-Clips

and other axles);

c) Jacking up the axle; securely resng it on jack stands;

The LOCK-RIGHT is designed to be used with a correct

thrust washer under each coupler, and failure to use this washer

is easy to observe during inspecon and will void the warranty.

A word about C-Clips: Many integral carrier dieren-

als have the axle shas retained by C-Clips. These are semi-cir-

cular pieces of hardened steel, similar to a washer with one side

cut out, that t into a groove in the end of the axle sha and into

a pocket in the side gear. The axle sha is held in place by the

pinion (spider gear) sha. The LOCK-RIGHT is designed for many

of these axles, and their installaon is covered in this manual.

This type of axle is the easiest in which to install a LOCK-RIGHT,

typically requiring about one hour for the procedure.

NOTE: The parts shown in the various gures are typical

and may not exactly depict your parcular model.

1 2 3 4 5 6 7 8 9 ... 27 28

Keine Kommentare

Powertrax 3710 Bedienungsanleitung Seite 4